Shoppen NachKategorien
0
ZURÜCK
KOSTENLOS
Machen Sie mehr draus: 5% zurück in Rakuten Super Points
JETZT MEHR SPAREN
Pololu
NUR NOCH 4 STÜCK

Pololu Carrier with Sharp GP2Y0A60SZLF Analog Distance Sensor 10-150cm, 3V

  • 12,95
  • inkl. MwSt.
  • Mit Code nur
  • Versandkosten: 4,50 €
  • Lieferung in 1-3 Werktagen
Leider ist der Artikel in dieser Variante nicht mehr verfügbar.
Leider ist der Artikel nicht mehr verfügbar.
Leider ist der Artikel nicht mehr verfügbar.

Produktbeschreibung

Overview

Sharp’s distance sensors are a popular choice for many projects that require accurate distance measurements. This particular sensor is small and affordable, making it an attractive alternative to sonar rangefinders, while its wide sensing range and resistance to interference from ambient IR set it apart from other IR distance sensors. It consists of a Sharp GP2Y0A60SZLF module installed on our compact carrier board, which includes all of the external components required to make it work and provides a 0.1? pin spacing that is compatible with standard connectors, solderless breadboards, and perfboards. With an ability to measure distances from as close as four inches to as far as five feet (10 cm to 150 cm), this sensor has the widest range of any of our Sharp distance sensors, and its 60 Hz update rate is more than twice that of Sharp’s older GP2Y0A02YK0F analog distance sensor that has a similar sensing range.

Interfacing to most microcontrollers is straightforward: the single analog output, OUT, can be connected to an analog-to-digital converter for taking distance measurements, or the output can be connected to a comparator for threshold detection. The sensor automatically updates the output approximately every 16 ms. The enable pin, EN, can be driven low to disable the IR emitter and put the sensor into a low-current stand-by mode. This pin is pulled high on the carrier board through a 10 kO pull-up resistor to enable the sensor by default.

A 1×4 strip of 0.1? header pins and a 1×4 strip of 0.1? right-angle header pins are included, as shown in the picture below. You can solder the header strip of your choice to the board for use with custom cables or solderless breadboards, or you can solder wires directly to the board itself for more compact installations. The board features one 0.125? mounting hole that works with #4 or M3 screws (not included); if you do not need the mounting hole, you can cut that part of the board off to reduce its size.


Produktdaten

In Den Warenkorb
Entschuldigen Sie bitte!
Eckstein Komponente
  • Impressum
  • Versandkosten
  • Widerrufsrecht
  • AGB
  • Datenschutz
Digitales Produkt sofort erhalten:
Ich stimme ausdrücklich zu, dass Sie vor Ablauf der Widerrufsfrist mit der Ausführung des Vertrages beginnen. Mir ist bekannt, dass ich durch diese Zustimmung mit Beginn der Ausführung des Vertrages mein Widerrufsrecht verliere.
ZUSTIMMEN
ABBRECHEN